Skip to content
HomePatch Home Services
Menu

HVAC in Broward County, Florida

Broward cooling loads are long and humid. Condensers near the Atlantic see salt air. Inland equipment sees the same heat with less salt. Both are still inside the HVHZ if the job touches the structure or an opening.

A brick and siding house with a shingle roof, a columned porch, and palms in the front yard.
Photo from Pexels. Source. Pexels License. Commercial use allowed.

Broward County

Broward County is one of the two High Velocity Hurricane Zone counties in the Florida Building Code. The other is Miami-Dade. Fort Lauderdale, Hollywood, Pembroke Pines, Coral Springs, and the rest of the county share that zone, whether the house is on the beach or inland.

Ask for a load calculation and a matched indoor and outdoor unit. Ask where the condensate will drain in a summer downpour.

Angi's national HVAC and heat pump ranges are the figures we cite. The federal heat pump credit ended for equipment placed in service after December 31, 2025.

How the cities in this county differ

Salt air is a Fort Lauderdale, Hollywood, and Pompano Beach problem for outdoor equipment. Coral Springs, Pembroke Pines, and Plantation have the same long cooling season with less salt. Condensate drains matter in all of them. If the condenser is on a roof, ask who is responsible for the stand and the tie-down. That detail shows up on HVHZ jobs.

Fort Lauderdale

Fort Lauderdale runs from the Atlantic beach through the Intracoastal and the New River to inland neighborhoods. The whole city is in the High Velocity Hurricane Zone.

Downtown towers, canal houses, and inland single-family streets share the HVHZ rule and do not share the same flood exposure.

Hollywood

Hollywood has a beach, a broadwalk, the Intracoastal, and inland neighborhoods west of I-95. All of it is in the HVHZ.

Beach blocks and houses west of I-95 can use the same impact rule and still need different flood checks.

Pembroke Pines

Pembroke Pines is inland southwest Broward. Being away from the beach does not remove the High Velocity Hurricane Zone.

A lot of the housing is newer suburban construction with association rules on exterior appearance.

Coral Springs

Coral Springs is a planned inland city in northwest Broward. It is inside the HVHZ because the whole county is.

Master-planned streets often have association standards for windows and roofs on top of the city permit.

Pompano Beach

Pompano Beach includes an oceanfront, the Intracoastal, and inland areas west of I-95. The city permits work inside the city.

Older beach cottages and newer inland houses will not have the same opening sizes. The HVHZ rule still applies to both.

Plantation

Plantation is inland central Broward. It is not on the beach, and it is still in the High Velocity Hurricane Zone.

The housing mix includes established subdivisions and newer infill. Association rules are common and sit beside the permit.

Signs the system is done

Weak airflow, a system that runs all afternoon and never catches up, ice on the line, water around the air handler, and a condenser that trips its breaker are reasons to have it diagnosed. Age alone is not a diagnosis. A dirty coil, a failed capacitor, or a crushed duct can imitate a dead compressor.

Heat pump, central air, and SEER2

A brick and siding house with a shingle roof, a columned porch, and palms in the front yard.
Photo from Pexels. Source. Pexels License. Commercial use allowed.
A heat pump moves heat both ways. A straight air conditioner only cools.Heat pumpAir conditioner
Illustration of the idea. Efficiency still comes from the rated equipment and the ductwork.

A central air conditioner cools. It needs a separate heat source, often a furnace or electric strips. A heat pump cools and heats by moving heat. In a hot climate the cooling rating matters most. In a cold climate the heating rating, HSPF2, matters too, and a cold-climate heat pump is a different specification from a Florida heat pump.

The Department of Energy's 2023 standards FAQ says split-system air conditioners manufactured on or after January 1, 2023 have to meet 13.4 SEER2 nationwide, and split-system heat pumps have to meet 14.3 SEER2 and 7.5 HSPF2. Southeast and Southwest states, including Florida, Georgia, North Carolina, Texas, Arizona, and California, also apply a higher regional standard to split-system air conditioners at installation. SEER2 is a new test. Do not treat it as the same number as an older SEER sticker. ENERGY STAR's split-system heat pump criteria are at least 15.2 SEER2, 11.0 EER2, and 7.8 HSPF2.

Match the indoor coil or air handler to the outdoor unit. A new condenser on an old mismatched coil often will not deliver the SEER2 on the sticker. Duct leaks and a bad return can waste the new equipment. Ask for a load calculation. Square footage alone is not one.

Permits and inspections

Most building permits in Broward are issued by the city, not by the county. The county building division permits the Broward Municipal Services District and Fort Lauderdale International Airport, and it handles regional elevator work. The Board of Rules and Appeals hears code appeals and interpretations. It does not pull your permit for you.

Florida license records are public through the Department of Business and Professional Regulation. Look up the license before you pay a deposit. A city may also require local registration. The state record does not say whether the company is careful or available.

Look up the address on the FEMA Flood Map Service Center before you change the structure, a water heater location, or electrical equipment. This site does not assign a flood zone.

Published cost ranges

Angi's 2026 HVAC replacement guide says most homeowners spend $5,000 to $12,500, with a national average of $7,500. The same guide says a job with new ducts and extras can reach $22,000, lists central air at $3,900 to $7,900, and lists one heat pump band at $4,200 to $7,600. A separate 2026 Angi heat pump guide says most homeowners pay $4,236 to $7,942, with an average of $6,087. The two guides do not match to the dollar, so we cite both and do not invent a blend.

We do not publish a city or county average. Doing that without a public local source would be a guess.

What the schedule is made of

A hvac job usually runs measure, product choice, permit, order, install, then inspection. The long part is often the permit review and the factory lead time, not the day of installation. This page does not print a number of weeks, because lead times and building departments differ and a made-up range would be a guess.

Credits and programs

The IRS says the Energy Efficient Home Improvement Credit is not allowed for property placed in service after December 31, 2025. Through that date the credit was 30 percent, with annual caps that included $600 for windows and skylights and $2,000 for heat pumps. Those caps are history, not a 2026 discount. The Residential Clean Energy Credit is not allowed for expenditures made after December 31, 2025. The IRS treats that expenditure as made when the original installation is completed, so a 2025 deposit does not keep the credit for a system finished in 2026. This is a reading of IRS pages, not tax advice.

How to compare companies

Florida license records are public at the Department of Business and Professional Regulation. Look up the license before you pay a deposit. A city may also require a local registration. The state record does not tell you whether the person is available or careful.

A useful quote names the product or equipment model, what is torn out, who pulls the permit, what is excluded, and the payment schedule. A deposit can be reasonable. Paying the entire job before any work starts is a risk you do not have to take. Get two quotes against the same scope and see which assumptions differ.

  • The license number, and the name it is issued to.
  • Who pulls the permit, and in whose name.
  • What happens if hidden damage shows up.
  • The warranty on the product and the warranty on the labor, as two separate lines.

After the work

Change filters, keep the condensate drain clear, and hose the outdoor coil when it is packed with dirt. A humid climate punishes a clogged drain. That maintenance does not replace a load calculation when the equipment is being changed.

Questions

Who permits hvac work in Broward County?

Most building permits in Broward are issued by the city, not by the county. The county building division permits the Broward Municipal Services District and Fort Lauderdale International Airport, and it handles regional elevator work. The Board of Rules and Appeals hears code appeals and interpretations. It does not pull your permit for you.

Repair or replace hvac in Broward County?

Repair when the failure is local and the rest of the system is sound. Replace when the material itself has failed across the house or the permit requires a different product than the one you have.

Sources

Related pages

Tell us about the project